Nice to have it back to spec.
My Z4................... My way.
- Thread starter t-tony
- Start date
- Joined
- Dec 5, 2018
- Points
- 88
- Model of Z
- Z4 3.0Si Sport
Great job Tony, bet it feels good to have sorted that one.
One small matter arose yesterday, when we fitted the new plastic corner section to the N/S under tray/wheel arch liner there was a cable connector left over. We disconnected/reconnected the fog lamp (1), the outside air temp. sensor was removed from the broken piece of the old plastic and fitted into the new and reconnected (2), but this connector was left and we could not see anywhere it could have come from. Everything works as far as I can see. Any ideas Z4 owners?
Tony.
Tony.
- Joined
- Dec 5, 2018
- Points
- 88
- Model of Z
- Z4 3.0Si Sport
Did they ever fit front parking sensors ?
Not as far as I'm aware mate. I have a sneaky feeling that I removed something from under there after I broke the plastic panel. I remember tying up the outside Air temp. sensor at the time.
Tony.
Tony.
Following on from the front bumper issue I got a new rubber splitter and got it fitted today.
Also had the wheels all off and refreshed the disc hubs and callipers which were ready after a couple of years.
Tony.
Also had the wheels all off and refreshed the disc hubs and callipers which were ready after a couple of years.
Tony.
Looking good mate, the splitter gives a more aggressive stance 
Not bad going Tony the discs have held up well it didn’t seem that long ago that you did them.
They've had a fairly quiet life mate
But yeah, time does fly.
Tony.
But yeah, time does fly.Tony.
The very last bit of TLC on the front end done today. The number plate surround took a battering and the plastic was stretched out of shape so with the help of some G cramps, some pieces of flat metal and a heat gun I got it back into shape and looking almost like new. I'm pleased with my efforts.
Tony.
Tony.
Last edited:
Looking very nice indeed
Cheers Paul. It didn't break the bank either.
Tony
Tony
Haha looks good Tony, I like it
.
Where from?Cheers Paul. It didn't break the bank either.
Tony
This one Paul.
https://www.ebay.co.uk/itm/Universal-100-Car-Lip-Skirt-Protector-Front-Bumper-Spoiler-Side-Rubber-Splitter/183878053039?ssPageName=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649
I would also buy some of these,
https://www.ebay.co.uk/itm/A2-Stain...hash=item4417907657:m:mweqBCxBbp5T7-16F4aLN2g
Tony.
ps. If you have a "hole punch" use that to make holes for the screws about 5" apart.
this is the first time I spotted the link to your Z4 progress thread in your signature today! looks great and alot of hours and love gone to the car, well done to you