seat belt clips, for those pesky broken passenger side belt holders.
mad mods
- Thread starter littlefeller
- Start date
Ooooh I like those, dipped in carbon would be nice 
ooops butter fingers
Last edited:
now theres an ideaOoooh I like those, dipped in carbon would be nice
was thinking the same thing, but then i would have to delete my how too, no hardship i suppose. just seems a shame not to share.
You could always send me 2 sets, I will dip them and send one back
seems like a plan.
Wheres the how to Jason
i "accidentally" deleted it ooops, 
i could always re-post it.
i could always re-post it.
i "accidentally" deleted it ooops,
No its ok mate, I'll pm my address
removed in readiness for ebay
Last edited:
Ingenious pal, right where do I find some 2mm acrylic, what width is the off cut
will take some measurements later, i could send a couple of pieces up to you though the off cut is the same size as the seat belt thingys, the bit that breaks
though the off cut is the same size as the seat belt thingys, the bit that breaks
Yes please, if you want a dipped set, send them as wellwill take some measurements later, i could send a couple of pieces up to you
will do
suppose i should add this too - ASC and ABS re-code module, after swapping my module ( brought a second hand unit for £30 off ebay, same part number) it needed re-coding, here is how i did this using NSC EXPERT
- load profile expertmode
- F1 VIN/ZCS/FA
- F3 ZCS/FA
- Select E36
- Select ECU then any of the available modules should provide NCS with your cars details. e.g EWS, this will load the cars individule coding into NCS, then press back button.
- F4 process ECU and choose the ASCMK20 module
- F3 execute job, it will now write the coding for this module which was gathered during step 5.
- Done. NCS should complete successfully (hopefully), other members have followed this how to also successfully.
wow, just found the way to add decals to the belt clips, brilliant
Last edited: