Z3 rear window trim

Tyrrell

Newbie
Joined
Jul 24, 2020
Points
1
Hi.i am new to the forum. I have a 2001 Z3 and the rubber trim round the rear windscreen is coming away. My (not very good) local BMW dealer says I need a new roof! Some people say it is part of the plastic rear windscreen and I just need to replace that. Any advice as to what to do would be gratefully received.
 

Mint

Zorg Expert (I)
Supporter
British Zeds
East Anglian Crew
Joined
Sep 23, 2012
Points
222
Location
Stafford
Model of Z
2.2 Sport Individual
Hi @Tyrrell, :welcome: to the forum from me too in Staffordshire. If you do go down the route of a new roof, do not go to BMW. There are lots of places but one which gets lots of good feedback is Jack Smith in Swansea. About £350 now for a complete new roof fitted.
I had my 3.0 done there but lots on here have used him.;)
 

Shelly

Zorg Expert (I)
Supporter
British Zeds
East Anglian Crew
Joined
Jul 9, 2013
Points
201
Location
Norfolk
Model of Z
Z4 2.0 20i M Sport sDrive

Olliebeak

Zorg Addict
British Zeds
Joined
Nov 1, 2018
Points
64
Location
Choppington,Northumberland
Model of Z
Z4 2.5
I think it is part of the rear window, the fabric roof shrinks and the trim comes away and you end up with a gap usually on the corner. I roughly stitched mine together and applied some black sealant as it was just the corner. As I only use the car with the roof down it didnt matter.
If you want a proper job it might mean a new roof.
 

Bozzy

Zorg Guru (V)
Supporter
British Zeds
Joined
May 21, 2015
Points
191
Location
Long Eaton.
Model of Z
3 2.8
The rubber seal is part of the window.
For a genuine BMW window you're looking at over £200 + fitting, i paid a local trimmer £60 to fit mine.
This was 5 years ago and before I found out that a new roof with stitched in window was only £350 including fitting :rolleyes:.
 

Ianmc

Zorg Guru (IV)
British Zeds
The M44 Massive
Joined
Oct 12, 2014
Points
165
Location
New Forest
Model of Z
Z3 (M44)
A new rear window should fix that. If the hood is in otherwise good condition, that would be my way forward.:thumbsup:
 

JAC

Dedicated Member
British Zeds
Joined
May 3, 2020
Points
39
Location
Hampshire
Model of Z
2.2 M Sport
I had a similar but smaller issue. I stretched it back into position and sealed with super glue. You cannot tell now and it has passed a shower or two. Perhaps not a permanent fix but has worked for me.
 
Top