Diff case refurb

[Sean d]

This mornings work, took 3 hours from start to finish, Finished with POR15 and cold galv

 

[Ianmc]

Fantastic.

 

[andyglym]

This mornings work, took 3 hours from start to finish, Finished with POR15 and cold galv
View attachment 80733 View attachment 80734 View attachment 80735 View attachment 80736 View attachment 80737 View attachment 80738

Impressive stuff mate, this is going to be a show car when finished.

 

[Sean d]

Impressive stuff mate, this is going to be a show car when finished.

That all depends on if I run out of steam first pal

 

[t-tony]

Top job again Sean.

Tony.

 

[ZTec]

Can’t believe its the same one, just goes to show what can be achieved with elbow grease and determination, top job Sean.

 

[Mazza]

Thats is an amazing transformation, And has just set the standard for all refurbs now.

 

[5harp3y]

What tools / process did you use

 

[Redline]

But that’s only the outside

Nice work. Agree with the earlier comments - it can’t be the same diff!
Just needs a ceramic coating to keep it clean

 

[Redline]

oops - double post.

 

[Marvin]

Beautiful work , keeps me motivated!

 

[Sean d]

View attachment 80748

What tools / process did you use

Firstly I had to remove the layers of rust, in the worse places it was 4-5mm thick, for this I used a windy chisel on low pressure the process leaves it looking like this

Then I used a stone wheel, followed by various grinders and sanders plus wire wheels to get this

If you look at the first set of pics you can see all the tools on the table

 

[ZTec]

View attachment 80748
Firstly I had to remove the layers of rust, in the worse places it was 4-5mm thick, for this I used a windy chisel on low pressure the process leaves it looking like this
View attachment 80746
Then I used a stone wheel, followed by various grinders and sanders plus wire wheels to get this
View attachment 80747
If you look at the first set of pics you can see all the tools on the table

I take my hat off to you sir, most people would have taken one look at the job and said sod it, its under the car.

 

[Sean d]

I take my hat off to you sir, most people would have taken one look at the job and said sod it, its under the car.

In for a penny and all that, , I just can't stop myself, when I start something like this I can already picture the end result and that what I strive for all the way through.

 

[Althulas]

I just hoping mine isn’t that rusty. Top work as always Sean

 

[How 29]

Hard work always pays off. Well done

 

[Mint]

Great job Sean, not sure I'd have the patience for something that's not going to be seen

 

[Slam]

Top job !