Boot lid removal

[Oompedoomp]

Hey Zedders

Any instructions knocking about for how to remove the boot lid? Google drew a blank and couldnt find anything here (my search terms might be pants!).

Thanks in advance.

Si

 

[t-tony]

It's easy enough Si. I can write it down later on.

Tony.

 

[Oompedoomp]

Thanks Tony. Much appreciated.

 

[Mazza]

This is from Bentleys....hence Trunk not Boot

 

[Oompedoomp]

Nice one! Thank you.

 

[Sean d]

Nice one! Thank you.

Remeber to tape a cord on the cables before you pull them out, this leaves it in the routing place so you can pull them back through when refitting

 

[Oompedoomp]

Remeber to tape a cord on the cables before you pull them out, this leaves it in the routing place so you can pull them back through when refitting

Ooooo...good point! Cheers

 

[t-tony]

I'll just add a foot note to that Si. Use at least a couple of metres of string so that when you have pulled the wires through the end of the string is still outside the panel. Disconnect the string from the wires and tie both ends of the string together then it will still be there when you need to pull the wires back through. Also, as the wires aren't all the same length it helps if you tape the short ends to the longer ones as they're less likely to jam up when you pull.them through.

Tony.

 

[Mazza]

Dont make the mistake that I did by just removing the clips. Remove the wires from the black plastic clips, as it is a lot easier to pull them out. I also used a separate pull through on the third brake light.

You can see the three clips on the wire. I had to pull it back out and remove them !!!!

 

[hard top]

Disconnect the strong from the wires

And what ever you do, don't break the "strong" ....

 

[Dino D]

Very easy, I just dropped mine off a shelf and it was gone..

 

[Oompedoomp]

And what ever you do, don't break the "strong" ....

You're a star Cheers.

 

[t-tony]

You're a star Cheers.

No he's not Si, he's a pain in the ***.

Tony.