1.9 struggling to start

[KaiJepson]

Hi all,

My z3 recently has started to struggle to start, it's not a battery as it does try and occasionally will start but then rumbles down and stops again, after a few tries it will start properly and after 10 seconds it idles fine. I'm not sure what the problem could be and don't have a code reader as the z3 only has a 20 pin so need an adapter too.

 

[the Nefyn cat]

A code reader will save an awful lot of guessing and possibly expense. I've got an earlier version of one of these and it's pretty much essential, the adaptor leads aren't expensive, either. Not compared to what a garage will rook you, anyway.

Creator C310+ Fit for BMW MINI ABS SRS OBD2 Code Scanner Engine Diagnostic tool | eBay UK

Find many great new & used options and get the best deals for Creator C310+ Fit for BMW MINI ABS SRS OBD2 Code Scanner Engine Diagnostic tool at the best online prices at eBay UK! Free delivery for many products!

www.ebay.co.uk

 

[colb]

Good advice from the cat, code reader essential for all BMW's, the Creator 310 or 410 with a 20pin adapter will be a good buy. See if there are any codes and take it from there, could be a bad or dying camshaft sensor they do affect starting when they are failing. If you find a code for the camshaft sensor that would confirm its the issue. Replace with oem brand, no cheap brands always use Bosch or Siemens although I have had success using Hass brand sensors which are cheaper than oem brands. Also check all the rubber inlet boots and vacuum pipes across the engine for splits and holes that let unmetered air into the engine that has not been measured when passing through the Maf sensor.

 

[bonbon]

1. Wait for a few seconds after the instrument panel lights go out before starting
2. Check there are no leaks in the piping. (This is the most common problem - I just had this problem for 10 months and had leak in a problem in small pipe exiting from the MFC)

 

[TriumphZ3]

Mine does this rarely but just often enough to worry me - it starts first time but sometimes rumbles a bit as if down one cylinder, then picks up and drives perfectly. However if I park for a few minutes after a good warmup and try to start, sometimes it cranks for a long time. It's a rare occurrence but sometimes worries me. I have a good code reader and it shows nothing wrong.