Had the Z3 wheel alignment done today following from the new front suspension parts. When I picked it up, the guy said we found this wedged in jack stand Only gone and left the chuck there! Good job it was in tight!
Found this still insitu
- Thread starter bombur
- Start date
- Joined
- Nov 25, 2012
- Points
- 178
- Location
- Newport, South Wales,UK
- Model of Z
- Z3 M43 1.8 (1999) and Z4 E85 2.0i (2007)
Did he say how much it needed adjusting?
Last edited:
Not too much
Looking at the rear geo, think your well overdue a refresh.
The whole back end is twisting to the left with both wheels doing the same, also one rear wheel has over a degree more camber than the other, Looks like one bush has died.
Stick it on the wish list for winter!
Stick it on the wish list for winter!
In my eyes no, but its the whole rear axle out job.
- Joined
- Nov 25, 2012
- Points
- 178
- Location
- Newport, South Wales,UK
- Model of Z
- Z3 M43 1.8 (1999) and Z4 E85 2.0i (2007)
Well the front wasn't far out so our measuring was pretty good the new wishbones and ball joints obviously tightened things up as well. I think Lee makes a good observation on the rear he is the expert at rear end refurbs at Zedshed HQ